top of page
Intructions for Installing Address Blocks
1. Drill 1/4" diameter hole 2" deep with a masonry bit into the mortar joint at desired location. (see picture to right for example)
2. Screw small threaded side of anchor bolt into threaded insert of stone. (see picture to right for example)
3. Dry fit block to desired location to be sure block fits flush to wall and is in the ideal spot. (see picture below to right example)
4. Place block face down on soft surface and run 1/4" bead around perimeter of block. Be sure to keep bead approximately 1" from edge of block to allow room for expansion. (see picture to right for example)
5. Place block in desired location and apply pressure to insure proper bonding of adhesive.
bottom of page